CT 48 Silicone paint
zoom_out_map
chevron_left chevron_right

Ceresit CT 48 Silicone paint

Hydrophobic, vapour permeable paint for buildings’ facades and interiors

 

100% Secure

 

Next Day Delivery Available

 

Return or change products

Description

  • Manufactured in more than two hundred colours
  • Excellent vapour permeability
  • Especially resistant to dirt
  • UV resistant
  • Resistant to weather conditions
  • Easy to use
  • Amount required: depending on the smoothness and absorption of the substrate, on average approx. 0.3 l/m2 with two coatings

CT 48 ensures rapid moisture evaporation from the substrate, thus providing effective protection against outside dampness. The drop-pearl effect occurs upon wetting the paint coat, thus protecting the substrate and effectively reducing the concentration of atmospheric contamination on facades. Highly recommended for use on historical monuments, on traditional, renovation and aerated plasters. Suitable for use on Ceresit CT 35, CT 36 and CT 137 mineral plasters, Ceresit CT 60, CT 63, CT 64 acrylic plasters, Ceresit CT 72, CT 73 silicate plasters, Ceresit CT 74, CT 75 silicone plasters and Ceresit CT 174, CT 175 silicate-silicone plasters applied on traditional substrates and included in Ceresit Ceretherm thermal insulation systems.

The paint CT 48 may be applied on carrying, smooth, dry and clean substrates (free from any substances that decrease adhesion such as grease, bitumen, dust):

– concrete (age over 28 days)

– traditional cement plasters, lime-cement plasters and lime plasters (age over 14 days),

– thin-layer mineral and mineral-polymer plasters (age over 7 days),

– thin-layer acrylic, silicone and silicate-silicone plasters (age over 3 days),

– gypsum substrates (only inside the buildings) with the humidity below 1%, firstly primed with Ceresit CT 17,

– gypsum cardboards, gypsum-fibre boards (only inside the buildings), fixed according to the recommendations of the board manufactures, firstly primed with CT 17,

– strong paint coats with good adhesion to the substrate. Firstly uneven and damaged substrates should be repaired.

Plaster filler Ceresit CT 29 can be used for repairs. It is recommended to check the strength of the existing mineral layers. The existing dirt, layers of low strength, lime and adhesive paint coatings as well as the remainders of wall paper or glues should be completely removed. It is recommended to use washing devices. After being washed with water, the substrate should dry.

Before the paint application, the content of the container should be carefully stirred by means of the drill with a mixer for about 2 minutes. Usually it is sufficient to paint twice. Between the application of the subsequent layers at least 12- to 24-hour technological breaks should be maintained. CT 48 should be applied by means of a brush, roller or a spraying device. It is important to apply the paint evenly. If there is such a need, it is possible to add not more than 5 % of water and stir carefully. Use only stainless containers and tools. Work on one surface should be carried on without any breaks using the paint of the same badge number printed on each packaging or the content of containers with different badge numbers should be mixed together. The area not to be painted, e.g. windows, doors should be protected (e.g. with foil). Bushes, other plants, etc. should be protected as well. Any stains should be immediately rinsed with water. Tools should be washed carefully with water directly after being used.

Data sheet

Data sheet
Model
CT48
Usage/Coverage
approx. 0.3 L/sqm with two coatings
Size
15 L
Unit
bucket